Xconfiguration Cameras Camera [1; Xconfiguration Cameras Camera [N..7] Focus Mode - Cisco TelePresence MX700 Reference Manual

Cisco TelePresence MX700 and MX800

Introduction
xConfiguration Cameras Camera [1..7] Backlight DefaultMode
This configuration turns backlight compensation on or off. Backlight compensation is useful
when there is much light behind the persons in the room. Without compensation the persons
will easily appear very dark to the far end.
Requires user role: USER
Default value: Off
USAGE:
xConfiguration Cameras Camera n
where
DefaultMode
: Off/On
Off: Turn off the camera backlight compensation.
On: Turn on the camera backlight compensation.
xConfiguration Cameras Camera [1..7] Brightness Mode
Define the camera brightness mode.
Requires user role: USER
Default value: Auto
USAGE:
xConfiguration Cameras Camera n
where
Mode
: Auto/Manual
Auto: The camera brightness is automatically set by the system.
Manual: Enable manual control of the camera brightness. The brightness level is set
using the Cameras Camera [n] Brightness DefaultLevel setting.
Cisco TelePresence MX700 and MX800 API Reference Guide CE8.0, FEBRUARY 2016.
D15335.02
About the API xConfiguration xConfiguration
Backlight DefaultMode: DefaultMode
Brightness Mode: Mode
xCommand
xConfiguration Cameras Camera [1..7] Brightness DefaultLevel
Define the brightness level. Requires the Cameras Camera [n] Brightness Mode to be set to
Manual.
Requires user role: USER
Default value: 20
USAGE:
xConfiguration Cameras Camera
where
DefaultLevel
: Integer (1..31)
The brightness level.

xConfiguration Cameras Camera [n..7] Focus Mode

This setting applies to Camera [2..7] for single camera systems, and to HDMI [3..7] for dual
camera systems.
Define the camera focus mode.
Requires user role: USER
Default value: Auto
USAGE:
xConfiguration Cameras Camera
where
Mode
: Auto/Manual
Auto: The camera will auto focus once a call is connected, as well as after moving the
camera (pan, tilt, zoom). The system will use auto focus only for a few seconds to set
the right focus; then auto focus is turned off to prevent continuous focus adjustments of
the camera.
Manual: Turn the autofocus off and adjust the camera focus manually.
44
API Reference Guide
xStatus Appendices
n Brightness DefaultLevel: DefaultLevel
n Focus Mode: Mode
Copyright © 2016 Cisco Systems, Inc. All rights reserved.