Xconfiguration Sip Uri; Standby Configuration; Xconfiguration Standby Control; Xconfiguration Standby Delay - Cisco TelePresence MX700 Reference Manual

Cisco TelePresence MX700 and MX800

Introduction

xConfiguration SIP URI

The SIP URI (Uniform Resource Identifier) is the address that is used to identify the video
system. The URI is registered and used by the SIP services to route inbound calls to the system.
The SIP URI syntax is defined in RFC 3261.
Requires user role: ADMIN
Default value: ""
USAGE:
xConfiguration SIP URI: "URI"
where
URI
: String (0, 255)
An address (URI) that is compliant with the SIP URI syntax.
Cisco TelePresence MX700 and MX800 API Reference Guide CE8.0, FEBRUARY 2016.
D15335.02
About the API xConfiguration xConfiguration xCommand

Standby configuration

xConfiguration Standby Control

Define whether the system should go into standby mode or not.
Requires user role: ADMIN
Default value: On
USAGE:
xConfiguration Standby Control:
where
Control
: Off/On
Off: The system will not enter standby mode.
On: The system will enter standby mode when the Standby Delay has timed out.
Requires the Standby Delay to be set to an appropriate value.

xConfiguration Standby Delay

Define how long (in minutes) the system shall be in idle mode before it goes into standby mode.
Requires the Standby Control to be enabled.
Requires user role: ADMIN
Default value: 10
USAGE:
xConfiguration Standby Delay:
where
Delay
: Integer (1..480)
Set the standby delay (minutes).
76
API Reference Guide
xStatus Appendices
Control
Delay
Copyright © 2016 Cisco Systems, Inc. All rights reserved.