Front Door Panel Removal/Installation - Honda ACCORD HYBRID 2005 Service Manual

Front Door Panel Removal/Installation
Special Tools Required
• KTC t r i m tool set SOJATP2014 *
• T r i m pad remover, Snap-on A 177A or equivalent,
c o m m e r c i a l l y available
• Available t h r o u g h the A m e r i c a n Honda Tool and
Equipment Program; call 888-424-6857
NOTE: Use the appropriate tool f r o m the KTC t r i m tool
set to avoid damage w h e n prying components.
1. Lower the glass fully.
2. Using a t r i m t o o l , pry out on the rear portion of the
cover (A) to release the hooks (B, C), then remove
the cover and the screws securing the inner
handle (D).
F a s t e n e r L o c a t i o n s
• : S c r e w , 2
3. Remove the power w i n d o w switch panel (A).
- 1 Pry up on the rear edge of the switch panel
w i t h a t r i m tool to release the rear clip.
- 2 Pull out along the edge of the panel to release
the hooks (B) and front clip.
- 3 Disconnect the power m i r r o r switch connector
(C) (driver's) and the power w i n d o w switch
connector (D).
Driver's
F a s t e n e r L o c a t i o n s
Passenger's
Fastener Locations
> : Clip, 2
4. Remove the screw f r o m under the pull pocket cap
(A).
Fastener Location
• : Screw, 1
5. Remove the m i r r o r m o u n t cover (see step 2 on
page 20-28).
(cont'd)
20-7