Honda ACCORD HYBRID 2005 Service Manual page 1244

Steering
Steering Column Removal and Installation (cont'd)
5. A l i g n the bolt hole (A) on the steering joint w i t h the
g r o o v e (B) around the pinion shaft, and loosely
install the joint bolt (C). Be sure that the joint bolt is
securely in the groove in the pinion shaft. Pull on
the steering joint to make sure that the steering
joint is fully seated. Tighten the steering joint bolt
to the specified torque.
7. Reconnect the negative cable to the battery and do
the f o l l o w i n g items:
NOTE: If the IMA battery level gauge (BAT) displays
no segments, start the engine, and hold it between
3,500 rpm and 4,000 r p m w i t h o u t load (in Park or
neutral) until the BAT displays at least three
segments.
• Power w i n d o w control unit reset procedure
(see page 22-200).
• Enter the anti-theft codes for the radio and the
navigation system, then enter the X M radio
channel presets.
• Set the clock.
• Verify cruise control, audio r e m o v e , navigation
voice control, and t u r n signal switch operation.
• Make sure the steering w h e e l is centered.
C
28 N m
(2.9 k g f m ,
21 Ibfft)
Make sure the all connectors are properly
connected, then install the steering wheel
(see page 17-8).
17-12