Honda ACCORD HYBRID 2005 Service Manual page 1892

Power Windows
D T C T r o u b l e s h o o t i n g
DTC B1125: Driver's Power W i n d o w Motor A
Pulse Error
DTC B1126: Driver's Power W i n d o w Motor B
Pulse Error
1. Open and close the driver's power w i n d o w by
using the driver's switch manually.
2. W h i l e the power w i n d o w m o v i n g , select POWER
W I N D O W S f r o m the HDS and enter the DATA LIST.
3. Check the EXIST/NONE i n f o r m a t i o n of the P/W
PLSA (B1125) or P/W PLSB (B1126) in the DATA
LIST.
Do the information indicators display EXIST?
YES—Replace the power w i n d o w master switch. •
N O — G o t o step 4.
4. Refer to the power w i n d o w master switch input test,
check for continuity between the driver's power
w i n d o w m o t o r 6P connector and the power
w i n d o w master switch 23P connector (see page
22-204).
Are all the wire harnesses OK?
YES—Substitute a k n o w n - g o o d power w i n d o w
master switch, and recheck. If DTC is gone, the
original master switch is faulty; replace it. If the
DTC is still indicated, replace the driver's power
w i n d o w motor. •
NO—Repair a short or an open in the w i r e . B
DTC B1140: Driver's Power W i n d o w Position
Detect Circuit Error
1. Clear the DTCs using the HDS.
2. Cycle the ignition switch to OFF and then back ON
(ID.
3. Open and close the driver's power w i n d o w by
using the driver's switch manually.
4. Check for DTCs using the HDS.
Is DTC B1125 or B1126 indicated?
Y E S - T r o u b l e s h o o t the DTC B1125 or B1126
(see page 22-210). •
N O — G o t o step 5.
5. Reset the power w i n d o w control unit (see page
22-200).
6. Check for DTCs again using the HDS.
Is DTC B1140 indicated?
YES — F a u l t y door multiplex control unit; replace
the power w i n d o w master switch. •
NO—The system is recovered at this t i m e . •
22-210