Table of Contents
Advertisement
• • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • •
In This Section
o
Registering the 7847i/7847i-E
• • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • •
Registering the 7847i/7847i-E
Once you have initialized and programmed the 7847i/7847i-E, it must be registered to enable
the account. An unregistered unit is indicated on the Status Display LEDs as: Status lit,
Message slow blinking, and Fault not lit. The Internet Link may be lit or blinking. Refer to
Appendix A for a detailed discussion of LED operation.
Figure 9. Unregistered 7847i/7847i-E Status Display In Normal Operation
Throughout this document, the following key is used to describe LED state:
To complete the registration process, a 7847i/7847i-E transmits a registration message and
receives a registration validation indicating that the account is now enabled.
You can register the 7847i/7847i-E by one of the following methods:
•
•
•
•
Registering through AlarmNet Direct Website (does not apply if using Private LAN)
If you have programmed the module through AlarmNet Direct, you must then transfer the
data to the module, and register the module.
To do this, please go to: https://services.alarmnet.com/AlarmNetDirect/userlogin.aspx.
Log in and follow the on-screen prompts.
Please have the following information available when programming the device:
1. Primary City ID (two-digit number)
2. Primary Central Station ID (two-digit hexadecimal number)
3. Primary Subscriber ID (four-digit number)
4. MAC ID and MAC CRC number (located on outside of box and on label inside
5. Once module is registered, you may log out of the AlarmNet Direct website.
ON
OFF
Figure 10. LED Key
Through the AlarmNet Direct website
Through use of the Tamper Switch
Through use of a 7720P Programming Tool
By phone.
module)
STATUS, GREEN
MESSAGE, YELLOW
FAULT, RED
FAST BLINK
S E C T I O N
Registration
SLOW BLINK
4
4-1
Hide quick links:
Advertisement
Table of Contents
