Honeywell AlarmNet 7847i-E Installation And Setup Manual page 17

NOTE: The default programming values for ECP mode are listed in each prompt below.
PROMPTS
Strt Prog Mode?
1
(Y/N)_
Enter Password:
2
Program Device?
3
(Y/N)_
Create Password?
4
(Y/N)_
Change Password?
5
(Y/N)_
Enter Password
6
Verify Password
7
Exit Prog. Mode?
8
(Y/N)_
Device Mode
9
(ECP)_
Users can receive email notification of system events by using the Multi-Mode feature. In ECP mode, this is
accomplished through emulation of a 4204 relay module, or two 4204 relay modules. When "4204-Sourced" is
selected, the user can be notified of up to four events, plus two additional events if using the optional communication
device zones of 6 and 7. When "2-4204-Sourced" is selected, the user can be notified of up to eight system events.
Table 3: Programming a 7847i-E for ECP mode only.
ENTRY OPTIONS
[Y], [N]
[0-9, A-F, N, S,
T, X, Y]
[Y], [N]
[Y], [N]
[Y], [N]
[0-9, A-F, N, S,
T, X, Y]
[0-9, A-F, N, S,
T, X, Y]
[Y], [N]
[ESC]
• ECP
• Zone Triggers
• 4204 Emu
• Two 4204s
Important Information Regarding Multi-Mode Options
Section 3: Programming the 7847i/7847i-E
DESCRIPTION
Enters programming mode.
If a password has been previously assigned, this
prompt appears.
Enter a 4-digit password (0-9, A-F, N, S, T, X, Y).
The next prompt appears.
To begin programming the module, press [Y] and go to
Prompt 9: "Device Mode."
To create a password if none has been assigned, press
[N] and go to Prompt 4: "Create Password."
To change an existing password, press [N] and go to
Prompt 5: "Change Password."
Passwords can be used to protect account and
programming information.
If no password has been assigned, this prompt appears
after pressing [N] at the "Program Device?" prompt.
If a password is desired, press [Y] and go to Prompt 6:
"Enter Password."
If a password has already been assigned, this prompt
appears after pressing [N] at the "Program Device?"
prompt.
Press [Y] if you want to change the password.
NOTE: To clear an existing password, without entering
a new one, answer [Y] to the "Change Password?"
prompt, then press the [Enter] key when prompted for
the new password and its confirmation.
This prompt is displayed if [Y] was pressed in Prompt 4
or 5.
Enter a 4-digit password (0-9, A-F, N, S, T, X, Y).
Re-enter the password as confirmation.
If the password doesn't match the first entry, the
following is displayed followed by the "Exit Prog.
Mode?" prompt:
Verify Not OK
PSWD not created
Otherwise, the "Exit Prog. Mode?" prompt is displayed
directly.
Exits program mode.
Press [N] to go back to Prompt 3.
Press [ESC] to load factory defaults.
Refer to the Exiting Programming Mode paragraph in
this section.
Press the [space] key to scroll through the modes of
operation. Press [ENTER] to select ECP mode.
See Table 5 if programming other modes.
3-3