Safety And Information - Honeywell touchpoint Pro Operating Instructions Manual

MAN0923_Issue 3_04/15

1. Safety and Information

The Equipment referred to in this manual contains components and assemblies that are each certified for
use in a variety of differing environments, and it is the site owner's responsibility to confirm the suitability of
the equipment prior to its installation and use.
The Equipment assemblies referred to in this manual are collectively certified for use in a flammable gas
detection system only. Any other use is not currently certified and is not authorised by the manufacturer.
For installation in Canada and the USA, for both ordinary and hazardous locations, all connections, cabling,
overcurrent protection and installations must strictly adhere to both the National Electrical Code (NEC) and
the Canadian Electrical Code (CEC).
Please check the product rating plate and look for the following marks to ensure that the supplied
equipment is suitable for its intended location and purpose:
Products bearing the CE mark conform to all applicable European Directives as stated on the
Honeywell product specific EC Declaration of Conformity.
Products bearing the CSA mark conform to the requirements for Ordinary Locations, and where
marked on components and apparatus, Zone 2 and Division 2 Hazardous Locations.
Products, components and apparatus bearing the ATEX Explosion Protection mark conform to the
requirements for Zone 2 Potentially Explosive Atmospheres.
FOR SAFETY REASONS THIS EQUIPMENT MUST BE OPERATED BY QUALIFIED PERSONNEL
ONLY. READ AND UNDERSTAND THE INSTRUCTION MANUAL COMPLETELY BEFORE
OPERATING OR SERVICING THE EQUIPMENT.
POUR DES RAISONS DE SÉCURITÉ, CET ÉQUIPEMENT DOIT ÊTRE UTILISÉ, ENTRETENU
ET RÉPARÉ UNIQUEMENT PAR UN PERSONNEL QUALIFIÉ. ÉTUDIER LE MANUEL
D'INSTRUCTIONS EN ENTIER AVANT D'UTILISER, D'ENTRETENIR OU DE RÉPARER
L'ÉQUIPEMENT.
WARNING
ATTENTION
8
Touchpoint Pro
Operating Instructions