Safety Hazards - Honeywell touchpoint Pro Operating Instructions Manual

MAN0923_Issue 3_04/15
1. Safety and Information

1.2 Safety Hazards

The following specific hazards are associated with the use of this equipment:
be installed in safe areas where there are no flammable atmospheres, and no
ATEX/IECEx Zone 2, Class I Div 2 and Class I (Zone 2) safe, but this enclosure can
ATEX certified components may be used within the Touchpoint Pro, and these bear
RCCB), and (close by and unobstructed) a means of manually isolating and locking
opening electrical access panels. Ensure residual current is fully discharged before
The Protective Earth (Ground) symbol is shown on the left, and it always has a green
Suitable respiratory, eye and skin protection should be worn when servicing these
Danger – Ignition Hazard
The Touchpoint Pro Controller is NOT ATEX/IECEx safe, and it may only
oxygen concentrations >25% v/v O
The Touchpoint Pro range includes a wall mounted enclosure that is certified as
Warning – Lethal Voltage present
All power supplies must be hard wired and must include a circuit breaker (RCD /
out the power supply without breaking the true earth (ground) connection.
Removable plug and socket connection is not permitted under any circumstance.
Warning – Lethal Voltage present
Lethal voltage may be present in this equipment when electrical power is applied.
There is a danger of death or injury from electrical shock. Isolate power before
Warning – Lethal Voltage present
Lethal voltage may be present both internally and externally to the system.
All installations, including cabinets, racks and remote units, must be connected
to true earth, and must be capable of staying earthed (grounded) when the power
Do not confuse it with the chassis earth symbols shown below it.
Warning – Toxic Waste and Harmful By-products
Toxic waste and harmful by-products may accumulate within parts of the system.
items. Stringent industrial hygiene precautions should also be taken. Do not allow
non-essential personnel into the work area.
The Touchpoint Pro system and/or its sensors may become contaminated by
the ambient environment in which it or they are used. It is the Customer's sole
responsibility to ensure that all appropriate safety precautions are taken before
handling any components or transferring them to any other party.
only be installed as a remote unit.
the ATEX imprint shown to the left.
touching live terminals.
supply is interrupted.
background.
12
Touchpoint Pro
Operating Instructions
.
2