Enabling Accounting Augmentation - Cisco Catalyst 4500 Series Software Configuration Manual

Configuring Device Sensor
Command
Step 1
configure terminal
Switch# configure terminal
Step 2
profile flow
Switch(config)# profile flow
Step 3
end
Switch(config)# end
Use the no form of the profile flow command to disable MSP.

Enabling Accounting Augmentation

For the Device Sensor protocol data to be added to accounting messages, you must first enable session accounting by using the
following standard Authentication, Authorization, and Accounting (AAA) and RADIUS configuration commands:
Switch(config)# aaa new-model
Switch(config)# aaa accounting dot1x default start-stop group radius
Switch(config)# radius-server host{hostname|ip-address}[auth-port port-number][acct-port port-number]
[timeout seconds][retransmit retries][key string]
Switch(config)# radius-server vsa send accounting
To add Device Sensor protocol data to accounting records, follow these steps, beginning in privileged EXEC mode:
Command
Step 1
configure terminal
Switch# configure terminal
Step 2
device-sensor accounting
Switch(config)# device-sensor
accounting
Step 3
end
Switch(config)# end
Creating a Cisco Discovery Protocol Filter
To create a CDP filter containing a list of TLVs that can be included or excluded in the Device Sensor output, follow these
steps, beginning in privileged EXEC mode:
Command
Step 1
configure terminal
Switch# configure terminal
Step 2
device-sensor filter-list cdp list
tlv-list-name
Switch(config)# device-sensor
filter-list cdp list cdp-list
Catalyst 4500 Series Switch, Cisco IOS Software Configuration Guide - Cisco IOS XE 3.9.xE and IOS 15.2(5)Ex
49-118
Chapter 49
Purpose
Enters global configuration mode.
Enables MSP.
Returns to privileged EXEC mode.
Purpose
Enters global configuration mode.
Enables the addition of sensor protocol data to accounting records and
also enables the generation of additional accounting events when new
sensor data is detected.
Returns to privileged EXEC mode.
Purpose
Enters global configuration mode.
Creates a TLV list and enters CDP sensor configuration mode, where
you can configure individual TLVs.
Configuring 802.1X Port-Based Authentication