Table of Contents
Advertisement
CHAPTER 3: INTERFACES
Creating a new
setpoint file
339 MOTOR PROTECTION SYSTEM – INSTRUCTION MANUAL
1.
In the files pane, right-click on Files and select the Add Existing Setting File item as
shown:
2.
The Open dialog box will appear, prompting the user to select a previously saved
setpoint file. As for any other MS Windows® application, browse for the file to be
added then click Open. The new file and complete path will be added to the file list.
The software allows the user to create new setpoint files independent of a connected
device. These can be uploaded to a relay at a later date. The following procedure illustrates
how to create new setpoint files.
1.
In the File pane, right click on File and select the New Settings File item. The following
box will appear, allowing for the configuration of the setpoint file for the correct
firmware version. It is important to define the correct firmware version to ensure that
setpoints not available in a particular version are not downloaded into the relay.
SOFTWARE SETUP
3–21
Advertisement
Table of Contents
