CHAPTER 3: INTERFACES
Flash messages
339 MOTOR PROTECTION SYSTEM – INSTRUCTION MANUAL
Flash messages are warning, error, or general information messages displayed in response
to pressing certain keys.
Figure 8: Typical Flash message
S3 SHORT CIRCUIT
SETPOINT STORED
This flash message is displayed in response to the ENTER key while on any setpoint
message (see example above). The edited value was stored as entered.
COMMAND EXECUTED
This flash message is displayed in response to executing a command: ON, OFF, YES, NO,
etc.
INVALID PASSWORD
This flash message appears upon an attempt to enter an incorrect password, as part of
password security.
BLOCK 1
Logic Element 8
<SETPOINT STORED>
FRONT CONTROL PANEL INTERFACE
3–9