Table of Contents
Advertisement
CHAPTER 3: INTERFACES
Flash messages
339 MOTOR PROTECTION SYSTEM – INSTRUCTION MANUAL
Table 3-2: Major Self-test Errors
Self-test Error
Latched
Message
Target
Message?
UNIT FAILURE:
Yes
Contact
Factory (XXXX)
RELAY NOT
No
READY: Check
Settings
* Failure is logged after the detection of 5 consecutive failures - that is after 25 seconds
Flash messages are warning, error, or general information messages displayed in response
to pressing certain keys. The factory default flash message time is 4 seconds.
Figure 3-8: Typical Flash message
S3 SHORT CIRCUIT
SETPOINT STORED
This flash message is displayed in response to the ENTER key while on any setpoint
message (see example above). The edited value was stored as entered.
COMMAND EXECUTED
This flash message is displayed in response to executing a command: ON, OFF, YES, NO,
etc.
INVALID PASSWORD
This flash message appears upon an attempt to enter an incorrect password, as part of
password security.
Description of
How Often the Test
Problem
is Performed
This warning is
Every 5 seconds*
caused by a unit
hardware failure.
Failure code (XXXX) is
shown.
PRODUCT SETUP
On power up and
INSTALLATION
whenever the
setting indicates that
PRODUCT SETUP
relay is not in a
INSTALLATION
programmed state.
setting is altered.
BLOCK 1
Logic Element 8
<SETPOINT STORED>
FRONT CONTROL PANEL INTERFACE
What to do
Contact the factory and
provide the failure code.
Program all required
settings then set the
PRODUCT SETUP
INSTALLATION setting to
"Programmed".
3–11
Advertisement
Table of Contents
