Table of Contents
Advertisement
Installation
ANN-I/O Connection to FACP
The ANN-I/O connects to the FACP via the ANN-BUS as illustrated in Figure 2.23. After the
ANN-I/O is connected to the panel, it must be added to the system via FACP programming.
FACP
TB3
ANN-I/O Module LED Wiring
There are four 12-pin connectors on the ANN-I/O module for connecting LEDs. Each set of 10
LEDs get their power from Pin 11 of the corresponding connector. Internal resistors are sized so
that there is approximately 10 mA of current for each LED. No series resistors are required. LED
outputs are mapped to output circuits. Refer to the section titled "ANN-I/O LED Zone Assign-
ments" on page 72 of this manual.
46
Primary ANN-BUS
Figure 2.23 ANN-I/O Connection to FACP
MRP-2002 Series Instruction Manual — P/N 53049:E5 7/28/2016
ANN-I/O Module
ANN-BUS and power wiring are
supervised and power-limited
ANN-BUS Devices
Advertisement
Table of Contents
