Installing A Dimm - HP ProLiant DL580 Setup And Installation Manual

Installing a DIMM

To install a DIMM:
1. Remove the memory board. Refer to "Removing a Memory Board" in this
chapter.
2. Observe all DIMM installation requirements for the desired memory mode. Refer
to the "DIMM Installation Requirements" sections for each mode in this chapter.
IMPORTANT: Follow all DIMM configuration requirements carefully. If the DIMMs are not
configured properly, you receive an error message during POST and the DIMM LEDs
blink amber.
3. Align the keyed portion of the bottom of the DIMM with the tab in the DIMM.
4. Press the DIMM firmly into the slot (1) and push the latches into place (2).
IMPORTANT: The bottom edge of the DIMM is designed so that it fits into the DIMM slot
only one way.
Figure 6-6: Installing a DIMM
HP ProLiant DL580 Generation 2 Server Setup and Installation Guide
Memory
6-23