Access Panels - HP ProLiant DL580 Setup And Installation Manual

Installing Hardware Options

Access Panels

The ProLiant DL580 Generation 2 server has front and rear access panels that may
need to be opened and removed to access the system board, processors, memory
slots, expansion slots, and other internal components. Observe the following
warnings and cautions when removing the access panels.
WARNING: Before removing the access panels for non-hot-plug hardware
options, be sure that the power cords are disconnected from the electrical
outlet.
WARNING: Pressing the Power On/Standby button sets the server to the
standby position, which removes power from most areas of the server.
However, portions of the power supply and some internal circuitry remain
active until the AC power cord is removed.
WARNING: To reduce the risk of personal injury from hot surfaces, allow the
internal system components to cool before touching.
CAUTION: Electrostatic discharge can damage electronic components. Properly
ground yourself before beginning any installation procedure.
5-12 HP ProLiant DL580 Generation 2 Server Setup and Installation Guide