Securing The Pci-X Retaining Clip - HP ProLiant DL580 Setup And Installation Manual

PCI-X Technology
12. Close the PCI-X retaining clip (for full-length expansion boards only).
Figure 7-11: Securing the PCI-X retaining clip
13. Connect any required cables to the expansion board.
14. Press the PCI-X Hot Plug button or use the PCI-X Hot Plug Utility to power up
the PCI-X Hot Plug slot.
15. Wait until the amber LED is off and the green LED stays on to be sure that you
have installed the board properly.
16. Replace the rear access panel. Refer to "Replacing the Access Panels" in
Chapter 5, "Installing Hardware Options."
17. Restore the server to its operating position in the rack.
18. Configure the expansion board using the documentation and software that ships
with the expansion board.
NOTE: For information about using a PCI-X Hot Plug Utility for installations with system
drivers, refer to "PCI-X Hot Plug Utilities" in this chapter.
7-16 HP ProLiant DL580 Generation 2 Server Setup and Installation Guide