Enhanced Auto-Configuration Process; Configuring The Memory - HP ProLiant DL580 Setup And Installation Manual

Server Configuration and Utilities

Configuring the Memory

To configure memory through RBSU:
1. Press the F9 key to enter RBSU.
2. Select Advanced Options.
3. Select Advanced Memory Protection.
4. Select the memory mode.
5. Press the Enter key.
6. Press the Esc key twice to return to the main RBSU menu.

Enhanced Auto-Configuration Process

During the power-up sequence that occurs the first time that the server is booted, the
system ROM automatically configures the entire system without any user
intervention.
By default setting, the system is configured for Microsoft Windows 2000. To change
any default settings in the auto-configuration process, load RBSU by pressing the F9
key. This allows you to select the language, operating system, and primary boot
controller for the server. Once these settings are set according to your preference, exit
RBSU and reboot the server.
The system then attempts to boot first from a bootable CD before booting from the
hard drive. For normal operating system installation, insert the operating system
installation CD into the CD-ROM drive. If ProLiant Essentials Foundation Pack
supports an assisted installation for the operating system you are installing, insert
ProLiant Essentials into the CD-ROM drive for an assisted installation.
If a POST error occurs, the system halts, pending a user selection from the menu. To
continue the boot process, press the F1 key, or select one of the other options on the
menu.
10-10 HP ProLiant DL580 Generation 2 Server Setup and Installation Guide