Table of Contents
Advertisement
11.
Connect the 4-pin connector of the USB interface cable to the internal USB floppy disk
drive.
NOTE:
Pay attention to orientation of the USB connector. The USB
connector cannot be inserted reversely.
12.
Connect the other side (10-pin connector) of the USB interface cable that comes with the
internal USB floppy disk drive to the connector for USB device located on mother board.
NOTE:
If any other USB device than the internal USB floppy disk
drive has been installed in the server, this step is unnecessary.
Connector for USB device
Upgrading Your Server 9-65
Advertisement
Table of Contents
