Table of Contents
Advertisement
9-58 Upgrading Your Server
Installation
Install a file device in the following procedure. Explanations are for factory-installed file bay.
Explanation specific for hard disk drive installing kit is also described.
SCSI Device
1.
Provide the proper setting for the device.
See the table below for the settings of the devices which can be installed in the device bay.
Device
SCSI device
*
If the terminator is not connected to the optional internal SCSI cable, set the termination
resistance to ON.
IMPORTANT:
unique.
2.
See the section "Preparing for Installation and Removal" described earlier to prepare.
3.
Remove the left side cover and front mask as described earlier in this chapter.
NOTE:
conversion kit, remove the dummy cover from the additional slot 2.
4.
Remove the two screws securing the dummy cover of the additional slot 1.
IMPORTANT:
Setting
Termination resistance: OFF*
SCSI ID for the device you are installing must be
If you are going to install the hard disk drive device bay
Keep the removed dummy cover for future use.
Advertisement
Table of Contents
