Table of Contents
Advertisement
4-90 Configuring Your Server
Manual Rebuild
Rebuild can be performed automatically when the failed Hard Disk Drive is replaced in hot-swap
mode. However, if the failed Hard Disk Drive is replaced after turning off the power of the server,
Rebuild will not start automatically. Use Manual Rebuild feature to recover the virtual drives as
described below.
IMPORTANT:
To perform rebuild by replacing the Hard Disk Drive in hot-swap
mode, be sure to replace the device while the operating system or
WebBIOS is running.
You can view the progress of rebuild process on Universal RAID
Utility screen or click [Virtual Drive] on WebBIOS Top Menu.
With the progress indication being displayed, the rebuild may be
processed at slow rate. Go to WebBIOS Top Menu after making
sure the rebuild progress.
Advertisement
Table of Contents
