Table of Contents
Advertisement
Cannot set Write-Back for cache mode:
The current cache mode of RAID controller is displayed on [Virtual Disks] -
→
[Properties] - [Policies] - "Write". If additional battery is faulty, is not connected,
or insufficiently charged, the cache mode is changed to "WThru (Write Through)"
even if you specify "WBack (Write Back)". See Chapter 4 for details.
Additional battery (N8103-123 or N8103-124) is not detected, or POST displays the
following message:
The battery hardware is missing or malfunctioning, or the battery is
unplugged, or the battery could be fully discharged. If you continue to
boot the system, the battery-backed cache will not function.
If battery is connected and has been allowed to charge for 30 minutes
and this message continues to appear, then contact technical support for
assistance.
Press 'D' to disable this warning (if your controller does not have a battery).
Are cables connected properly?
Check connection between battery pack and battery board, battery board and
→
battery connector and battery control cable.
Connect them properly.
Is battery connected immediately before?
The battery may not be detected if it is insufficiently charged. If the battery is not
→
detected even after 24 hours, restart the system.
If the same error persists, the additional battery may be faulty. Contact your
service representative.
Event ID129:
The following message appears on Windows Event Log.
Source:
Event ID:
Type:
Description:
Retry by OS has succeeded. It is not the problem in operating the system.
→
msas2k3
129
Warning
Information about Event ID (129) (Source: msas2k3) is not found.
-----
Troubleshooting 8-37
Advertisement
Table of Contents
