Safety - Bosch ICP-AMAX4-P1 Installation Manual

8 en | Safety
2

Safety

This system / product must be installed by a qualified installer / service person.
During installation and wiring, the AMAX power source must be switched off to prevent
equipment damage.
–
–
The User has to disconnect all Telecommunication Network Connectors before unplugging the
power adaptor.
After the AMAX panel wiring is completed, connect the AC power and backup batteries.
The mains indicator on the keypad will light up show that AC power is connected.
Notice!
- Use only non spillable battery
- Battery must be recycled
- When battery is not replaced correctly, risk of fire explosion or burning
- Replace the battery every 3-5 years under normal conditions of use
- Place a label with change date on the battery
Notice!
- The system / product must be installed and maintained by qualified installer / service
person.
- Bosch recommends testing the alarm system at least once a week.
Danger!
As static-sensitive components are included in PCBs, anti-static steps should be followed and
they should be carefully installed.
Before installing the alarm AMAX panel, the static electricity should be discharged by
connecting the grounding terminal of the AMAX panel.
2014.4 | 01 | F.01U.267.112
To switch off the power source, an easy accessible circuit breaker must be available
The system / product must be connected to a socket-outlet with a protective earthing
contact
Installation Guide
AMAX panel 4000 / AMAX panel 4000
Bosch Sicherheitssysteme GmbH
EN