Bosch ICP-AMAX4-P1 Installation Manual page 149

AMAX panel 4000 / AMAX panel 4000
EN
3.
RF Receiver Tamper
Condition:
When receiver tampered (eg., When someone removes the device from its base or pulls it
away from the wall ), if wireless module is enabled.
Restore:
The tamper restored and fault is reset.
Supervise:
1.
2.
3.
RF Repeater Tamper
Condition:
When repeater tampered (eg., When someone removes the device from its base or pulls it
away from the wall ), if wireless module is enabled.
Restore:
The tamper restored and fault is reset.
Supersive:
1.
2.
3.
8 - External Failure
Condition:
Fault contact (direct connected to the zone) is triggered (zone type = external fault)
Restore:
Fault contact is restored and fault condition is reset.
Supervise:
1.
2.
3.
External Fault Zone
The zone indicator 8 lights to indicate external fault conditions.
Bosch Sicherheitssysteme GmbH
When the keypad lock out condition is reset, send the restored report to the configured
destinations. The FAULT indicator is turned off when there is no other system fault.
Report receiver tamper fault to configured destination when the fault is detected.
Slow flash FAULT indicator (refer to Keypad Indicators for the detailed description).
When the fault is reset, send the restored report to the configured destinations. The
FAULT indicator is turned off when there is no other system fault.
Report repeater tamper fault to configured destination when the fault is detected.
Slow flash FAULT indicator (refer to Keypad Indicators the detailed description).
When the fault is reset, send the restored report to the configured destinations. The
FAULT indicator is turned off when there is no other system fault.
Report the fault condition to configured destination on address 124 when the fault
condition is detected.
Slow flash FAULT indicator (refer the detailed description in chapter keypad indicators).
When the fault is reset, send the restored report to the configured destinations. The
FAULT indicator is turned off when there is no other system fault.
Installation Guide
Troubleshooting | en 149
2014.4 | 01 | F.01U.267.112