Address And Key Programming; Address Programming; Programming With The Icp-Ezpk Programming Key - Bosch ICP-AMAX4-P1 Installation Manual

74 en | Settings
7.8

Address and Key Programming

7.8.1

Address Programming

Refer to Programming.
7.8.2

Programming with the ICP-EZPK Programming Key

The ICP-EZPK Programming Key allows you to save or copy programming information from
your AMAX panel. After saving information in the programming key, you can easily program
other AMAX panel with the same programming data. You can also use the programming key to
back up existing information.
If you have a new programming key, enter installer's programming mode, program the system
as required, and connect the programming key to the AMAX panel.
To connect the programming key:
Connect the programming key to the plug on top of the printed circuit board (PCB) of the
AMAX panel.
Notice!
Please note that the direction of the programming key should be consistent with the direction
marked on the PCB.
For example: To copy data from the AMAX panel to the programming key:
1.
2.
3.
4.
Caution!
If you do not enter installer's programming mode first, which connects the blank ICP-EZPK
!
Programming Key (blue) to the AMAX panel, no data can be uploaded / downloaded.
An unknown error may be caused if the installer's programming mode is not exited before
removing the programming key.
Programming Key
With the programming key, the programming parameters of the current AMAX panel to other
systems with the same applications.
Copying Parameters of the Alarm AMAX Panel to the Key
Copy the programming data in the memory of the AMAX panel into the programming key with
the keypad.
1.
2014.4 | 01 | F.01U.267.112
Enter the installer code (the default is 1234) + (958) and press [#] to enter into installer's
programming mode.
Enter [9 6 2 #]. Refer to Section 6.23 Command 962 – Copy the AMAX panel memory to
the programming key, page 46.
Enter [9 6 0 #] to exit from installer's programming mode.
The system resets and returns to the disarmed state. And the programming key becomes
your standard data pattern for future AMAX panel programming.
Connect the programming key to the plug on top of the printed circuit board (PCB) of the
AMAX panel. Please note that the direction of the programming key should be consistent
with the direction marked on the PCB.
Installation Guide
AMAX panel 4000 / AMAX panel 4000
Bosch Sicherheitssysteme GmbH
EN