Hitachi PC-ARF Technical Catalogue page 120

4 Individual remote controls
PC-ARF
7 Press " " or " " and select "Check interval".
8 The display is switched "30MIN", "60MIN", "90MIN", "120MIN"
and "180MIN" in order by pressing " " or " " and change the
setting.
9 Press "OK" after the setting is completed. The confirmation
screen is displayed then. Select "Yes" by pressing " " or
" " and press "OK". The motion sensor setting is confirmed
and the screen returns to the normal mode (operation mode
indication).

Adjusting date/time
This function is used to adjust the date and time.
Periodic time setting is recommended. (Clock accuracy: difference within +/-70 seconds by month).
As for this remote control switch, the clock can work up to 72 hours when power failure occurs. Reset the date and time if
the remote control switch remains without power supply for longer than 72 hours or main power supply is OFF for long time.
1 Select "Adjusting Date/Time" from the menu and press "OK".
2 Press " " or " " and select "yy/mm/dd/hh/mm".
3 Press " " or " " to change the setting. Press or keep pressing " " or " " to adjust numbers.
104
TCGB0106 rev.0 - 12/2014
Motion Sensor Setting
Sensor
If absent
OK
Check interval
SEL. ADJ
Motion Sensor Setting
Sensor
If absent
OK
Check interval
SEL. ADJ
Motion Sensor Setting
Save changes?
OK
Yes
SEL.
OK
Meeting Room
A/C
MODE SPEED
HEAT
MED
Motion Sensor is activated
OK
LOUV.
OK
Adjusting Date/Time
Function 13
SEL.
OK
ON
Running
30MIN
OK ENT. RTN.
ON
Running
30MIN
ENT. RTN.
OK
No
OK ENT. RTN.
LOUV. TEMP
ADJ
Fri
ENT. RTN.