Parameter Lists; Overview Of Measuring Cycle Parameters; Cycle973 Measuring Cycle Parameters - Siemens SINUMERIK 840D sl Programming Manual

Parameter lists

4.1

Overview of measuring cycle parameters

4.1.1

CYCLE973 measuring cycle parameters

PROC CYCLE973(INT S_MVAR,INT S_PRNUM,INT S_CALNUM,REAL S_SETV,INT S_MA,INT S_MD,REAL
S_FA,REAL S_TSA,REAL S_VMS,INT S_NMSP,INT S_MCBIT,INT _DMODE,INT _AMODE)
Table 4-1 CYCLE973 call parameters
No. Screen Cycle pa‐
form param‐ rameters
eters
1
S_MVAR
Measuring cycles
Programming Manual, 12/2017, 6FC5398-4BP40-6BA1
1)
Meaning
Measuring variant (default=0012103)
Val‐ UNITS: Calibration on a surface, edge or in a groove
ues:
0 = Length on surface/edge (in the WCS) with known setpoint
1 = Radius on surface (in the WCS) with known setpoint
2 = Length in groove (in the WCS), see S_CALNUM
3 = Radius in groove (in the WCS), see S_CALNUM
TENS: Reserved
0 = 0
HUNDREDS: Reserved
0 = 0
THOUSANDS: Selection of measuring axis and measuring direction for calibration
2)
0 = No specification (for surface calibration on the groove base, no selection of the
measuring axis and measuring direction)
1 = Specify selection of measuring axis and measuring direction, see S_MA, S_MD
(one measuring direction in a measuring axis)
2 = Specify selection of measuring axis, see S_MA (two measuring directions in a
measuring axis)
TEN THOUSANDS: Determination of the positional deviation (probe skew)
0 = Determine positional deviation
1 = Do not determine positional deviation
HUNDRED THOUSANDS: Reserved
0 = 0
ONE MILLION:adapt tool length
0 = Do not adapt tool length (only trigger points)
1 = Adapt tool length
4)
7)
4
2), 3)
301