Siemens SINUMERIK 840D sl Programming Manual page 334

Parameter lists
4.1 Overview of measuring cycle parameters
Table 4-13 CYCLE982 call parameters
No. Screen Cycle pa‐
form param‐ rameters
eters
1
S_MVAR
2 Selection
S_KNUM
3 Icon+
S_PRNUM
number
4 X0
S_MA
5 +-
S_MD
334
1)
Meaning
Measuring version
Val‐ UNITS: Calibration/measurement
ues:
0 = Calibrate tool probe
1 = Single tool measurement
2 = Multiple tool measurement, determine lengths and tool radius (for milling tools)
TENS: Calibration or measurement in the MCS or WCS
0 = Machine-related
1 = Workpiece-related
HUNDREDS: Measurement with or without reversal for milling tools
0 = Measurement without reversal
1 = Measurement with reversal
THOUSANDS: Correction target for milling tools
0 = determine length or length and radius (see S_MVAR 1st position)
1 = determine radius, if S_MVAR 1st position = 1
2 = determine length and radius (face side), if S_MVAR 1st position = 1 or 2
3 = side milling tool, upper cutting edge (rear side) and determine length and radius
5)
TEN THOUSANDS: Position of the milling tool or the drill
0 = Axial position of the milling tool or the drill, radius in 2nd axis of the plane (for
G18 X)
7)
1 = Radial position of the milling tool or the drill, radius in 1st axis of the plane (for
G18 Z)
7)
HUNDRED THOUSANDS: Incremental calibration or measurement
0 = No specification
1 = Incremental calibration or measurement
ONE MILLION: Position spindle at starting angle S_STA1 (only for measurement
of milling tools)
0 = spindle is not positioned
1 = spindle is positioned at the starting angle S_STA1
Offset variant
2)
Val‐ UNITS: Tool offset
ues:
0 = No specification (tool offset in geometry)
1 = Tool offset in wear
Number of the field of the probe parameters (not probe number)
(default=1)
Measuring axis
Val‐ 1 = 1. Axis of the plane (for G18 Z)
ues: 2 = 2nd axis of the plane (for G18 X)
Measuring direction
Val‐ 0 = No selection (measuring direction is determined from actual value)
ues: 1 = Positive
2 = Negative
3)
4)
Programming Manual, 12/2017, 6FC5398-4BP40-6BA1
Measuring cycles