Siemens SINUMERIK 840D sl Programming Manual page 160

Measuring variants
3.3 Measure workpiece (milling)
Parameter Description
Y4 Start position Y of the 4th measurement
Protection zone Use protection zone
● Yes
● No
DZ Infeed distance at measuring height (only for protection zone "Yes")
DFA Measurement path
TSA Safe area for the measurement result
Other parameters and correction targets can be set in the general SD 54760 $SNS_MEA_FUNCTION_MASK_PIECE .
1)
Note
The four measuring points or the measuring path DFA must be selected so that contour within
the total path: 2 · DFA [in mm] is reached. Otherwise, no measurement will be able to be made.
Internally in the cycle, a minimum value of 20 mm for the measurement distance DFA is
generated.
Parameter
G code program
Parameter Description
PL Measuring plane (G17 -
G19)
Calibration data set (1 - 40)
Parameter Description
Correction target
● Measuring only (no offset)
● Work offset (save measured values in a settable WO)
Coordinate system ● Polar
● Right-angled
Position Type of corner:
Outside corner
160
Machine manufacturer
Please observe the information provided by the machine manufacturer.
ShopMill program
Unit Parameter
- T
- D
X
Y
Z
Description
Name of the probe
Cutting edge number (1 - 9)
Calibration data set (1 - 40)
Start point X of the measurement
Start point Y of the measurement
Start point Z of the measurement
1)
Inside corner
Programming Manual, 12/2017, 6FC5398-4BP40-6BA1
Unit
mm
-
mm
mm
mm
Unit
-
-
-
mm
mm
mm
Unit
-
-
-
-
Measuring cycles