Result Parameters; Calibrate Probe - Calibrate On Ball (Cycle976) - Siemens SINUMERIK 840D sl Programming Manual

Measuring variants
3.3 Measure workpiece (milling)
3.3.5.3

Result parameters

List of the result parameters
The measuring version "Radius between two edges" provides the following result parameters:
Table 3-12
Parameter
_OVR [4]
_OVR [5]
_OVR [8]
_OVR [10]
_OVR [12]
_OVR [14]
_OVR [9]
_OVR[11]
_OVR[13]
_OVR[15]
_OVR[20]
_OVR[21]
_OVR[27]
_OVR[28]
_OVI[2]
_OVI[5]
_OVI[9]
The result parameters are written to, which correspond to the selected axis.
3.3.6

Calibrate probe - calibrate on ball (CYCLE976)

Function
Using this measuring method, a workpiece probe can be calibrated at any position in space.
This has a special meaning in conjunction with swivel functions and transformations.
124
"Radius between two edges" result parameters
Description
Actual value probe ball diameter
Difference probe ball diameter
Trigger point in minus direction, actual value of 1st axis of
the plane
Trigger point in plus direction, actual value of 1st axis of the
plane
Trigger point in minus direction, actual value of 2nd axis of
the plane
Trigger point in plus direction, actual value of 2nd axis of the
plane
Trigger point in minus direction, difference of 1st axis of the
plane
Trigger point in plus direction, difference of 1st axis of the
plane
Trigger point in minus direction, difference of 2nd axis of the
plane
Trigger point in plus direction, difference of 2nd axis of the
plane
Positional deviation of the 1st axis of the plane (probe skew) mm
Positional deviation of the 2nd axis of the plane (probe skew) mm
Work offset range
Safe area
Measuring cycle number
Probe number
Alarm number
Unit
mm
mm
mm
mm
mm
mm
mm
mm
mm
mm
mm
mm
-
-
-
Programming Manual, 12/2017, 6FC5398-4BP40-6BA1
Measuring cycles