Tool Offset Strategy; Correction Strategy For Tool Offsets When Measuring Tools Regarding Tool Groups (Replacement Tools) - Siemens SINUMERIK 840D sl Programming Manual

2.12

Tool offset strategy

2.12.1 Correction strategy for tool offsets when measuring tools regarding tool groups
(replacement tools)
For tool offset after measuring the workpiece, the measuring cycles always check the following
status of the tool:
● "Tool active" and
● "Tool has been in use"
Only tools with this status will be corrected, assuming that they are not locked.
Individual behavior of the measuring cycles
State
Precisely one tool of a tool group has the status
● "Tool active" and
● "Tool has been in use"
No tool was found associated with the tool name.
No tool with the status mentioned above was found in the tool
group.
Several tools with the status mentioned above were found in
the tool group.
Measuring cycles
Programming Manual, 12/2017, 6FC5398-4BP40-6BA1
Correction behavior
This tool is corrected. If the tool has the "locked" status, cycle
alarm 61404 "Tool correction not executed" is output.
A correction is not made, instead cycle alarm 61343 "Tool
does not exist" is output.
The tool is not corrected, but instead, cycle alarm 61404 "Tool
correction not executed" is output.
A correction is not made, instead cycle alarm 61344 "Several
tools are active" is output.
Description
2.12 Tool offset strategy
51