Siemens SINUMERIK 840D sl Programming Manual page 312

Parameter lists
4.1 Overview of measuring cycle parameters
No. Screen form Cycle pa‐
parameters rameters
3 Selection
S_KNUM1
4 Icon+num‐
S_PRNUM
ber
5 X0
S_SETV
6 DFA
S_FA
7 TSA
S_TSA
8 X
S_MA
9
S_MD
10 Measure‐
S_NMSP
ments
11 TR
S_TNAME
12 DL
S_DLNUM
13 TZL
S_TZL
14 DIF
S_TDIF
312
Meaning
Correction in tool offset
2)
Val‐ UNITS:
ues:
TENS:
HUNDREDS:
0 = No correction
1 to max. 999 D numbers (cutting edge numbers) for tool offset,
for additive and setup offset, see also S_DLNUM
THOUSANDS: 0 or unique D numbers
TEN THOUSANDS: 0 or unique D numbers
1 to max. 32000 if unique D numbers in MDs have been set up
HUNDRED THOUSANDS: Tool offset
0 = No specification (offset in tool geometry)
1 = Offset of length L1
2 = Offset of length L2
3 = Offset of length L3
4 = Radius offset
ONE MILLION: Tool offset
0 = No specification (offset of the tool radius wear)
1 = Tool offset, additive offset (AO)
Tool offset value is added to the existing AO
2 = Tool offset, setup offset (SO)
SO (new) = SO (old) + AO (old) offset value, AO (new) = 0
3 = Tool offset, setup offset (SO)
Tool offset value is added to the existing SO
4 = Tool offset, geometry
TEN MILLION: Tool offset
0 = No specification (offset in tool geometry normal, not inverted)
1 = Offset inverted
Number of the field of the probe parameters (not probe number)
(value range 1 to 40)
Setpoint
Measurement path
Safe area
Number of the measuring axis
Val‐ 1 = 1st axis of the plane (for G17 X)
ues: 2 = 2nd axis of the plane (for G17 Y)
3 = 3rd axis of the plane (for G17 Z) measurement in tool direction
Measuring direction of the measuring axis
Val‐ 1 = Positive measuring direction
ues: 2 = Negative measuring direction
Number of measurements at the same location
Tool name
3)
Setup additive offset DL number
Work offset
2), 3)
Dimensional difference check
2)
2)
5)
5)
5)
2)
(value range 1 to 3)
7)
(value range 1 to 9)
2)
5)
2), 3)
Programming Manual, 12/2017, 6FC5398-4BP40-6BA1
Measuring cycles