Additional Parameters - Siemens SINUMERIK 840D sl Programming Manual

Parameter lists

4.2 Additional parameters

4.2 Additional parameters
The following supplementary parameters can be hidden or unhidden using setting data in the
input screen forms. For more information about setting data SD54760 to SD54764, see the
List Manual
The supplementary parameter are not available for all measuring cycles. See also the interface
description.
Table 4-16 Supplementary parameters for workpiece measurement
Screen form pa‐ Transfer pa‐
rameters rameters
Calibration data set S_PRNUM
F
S_VMS
Selection
S_MVAR
Selection
S_MVAR
Number
S_NMSP
TZL
S_TZL
DIF
S_TDIF
Data set, mean val‐
S_EVNUM
ue generation
Data set, empirical
S_EVNUM
values
FW
S_K
TMV
S_TMV
Selection
S_MVAR
340
SINUMERIK 840D sl, detailed description of the machine data .
Machine manufacturer
Please observe the information provided by the machine manufacturer.
Description
Number of the data set with the calibrated values of the probe
Measuring feedrate when calibrating the probe
Calibrate probe: selection at the known or unknown center point of the cali‐
bration ring
Calibrate probe: selection, calibration with or without position deviation
(probe skew)
Number of measurements at the same location
Work offset for correction in a tool
Dimension difference monitoring for correction in a tool
Generating mean values for correction in a tool
Generating empirical values for correction in a tool
Weighting factor for averaging
Offset range for averaging
Measuring when turning, diameter inside outside:
● With reversal
● Travel under center of rotation
Programming Manual, 12/2017, 6FC5398-4BP40-6BA1
Unit
-
mm/min
-
-
-
mm
-
-
-
-
-
Measuring cycles