Cycle977 Measuring Cycle Parameters - Siemens SINUMERIK 840D sl Programming Manual

Parameter lists
4.1 Overview of measuring cycle parameters
Example for offset in coordinate rotation: S_MA=102 Measuring axis Y, offset axis X results in coordinate rotation around
4)
Z (for G17)
Value only relevant for protection zone "Yes" (S_MVAR THOUSANDS position = 1)
5)
When positioning from measuring point P1 to measuring point P2 in the offset axis, the angles in parameters S_STA1 and
6)
S_TSA are added.
Number of the measuring axis must not be the same as the number of the offset axis (e.g. 101 not permitted)
7)
Measuring direction only for "Align edge" and "Measurement paraxial" (S_MVAR=10x105)
8)
Angular range S_STA1 ±45 degrees for "Align edge"
9)
Angular range S_STA1 0 to +60 degrees and S_INCA ±30 degrees for "Align plane"
For measuring variants "Align plane" and "Align edge"
10)
For measuring variants "Measure plane" and "Measurement paraxial"
11)
Not for measuring cycle version SW04.04.
12)
Empirical value generation for correction in WO; value range of the empirical mean value memory:
13)
1 to 20 numbers of the empirical value memory, see channel-specific SD 55623 $SCS_MEA_EMPIRIC_VALUE[n-1]
4.1.7

CYCLE977 measuring cycle parameters

PROC CYCLE977(INT S_MVAR,INT S_KNUM,INT S_KNUM1,INT S_PRNUM,REAL S_SETV,REAL S_SETV0,REAL
S_SETV1,REAL S_FA,REAL S_TSA,REAL S_STA1,REAL S_ID,REAL S_SZA,REAL S_SZO,INT S_MA,INT
S_NMSP,STRING[32] S_TNAME,INT S_DLNUM,REAL S_TZL,REAL S_TDIF,REAL S_TUL,REAL S_TLL,REAL
S_TMV,INT S_K,INT S_EVNUM,INT S_MCBIT,INT _DMODE,INT _AMODE)
316
Programming Manual, 12/2017, 6FC5398-4BP40-6BA1
Measuring cycles