Siemens SINUMERIK 840D sl Programming Manual page 213

G code program
Parameter Description
Dimensional toler‐ Use dimensional tolerance
ance
● Yes
● No
TUL Upper tolerance limit of the angular deviation (only for dimensional tolerance "Yes")
Other parameters and correction targets can be set in the general SD 54760 $SNS_MEA_FUNCTION_MASK_PIECE .
1)
List of the result parameters
The measuring variant "machine geometry" provides the following result parameters:
Table 3-29
Parameters
_OVR [2]
_OVR [3]
_OVR [4]
_OVR [5]
_OVR [6]
_OVR [7]
_OVR [8]
_OVR [9]
_OVI [2]
_OVI [3]
_OVI [5]
_OVI [9]
Table 3-30
Parameters
_OVR [10]
_OVR [11]
_OVR [12]
_OVR [13]
_OVR [14]
Measuring cycles
Programming Manual, 12/2017, 6FC5398-4BP40-6BA1
Machine manufacturer
Please observe the information provided by the machine manufacturer.
Result parameter "Machine geometry" (CYCLE995)
Description
Actual angle between X and Z
(X = 1st axis of the plane for G17, Z = 3rd axis of the plane for G17)
Actual angle between Y and Z (Y = 2nd axis of the plane for G17)
Distance in Z between the probe ball and measuring position at the probe
shaft
Exceeding the tolerance between X and Z (for dimensional tolerance
"Yes")
Exceeding the tolerance between Y and Z (for dimensional tolerance
"Yes")
Spindle camber in XZ (XZ for G17)
Spindle camber in YZ (YZ for G17)
Upper tolerance limit of the measured angle values (_OVR[2], _OVR[3])
Measuring cycle number
Measuring version
Number, probe calibration data field
Alarm number
Intermediate results 1st measurement (calibration ball)
Description
Setpoint calibration ball
Setpoint center point coordinate, 1st axis of the plane
Setpoint center point coordinate, 2nd axis of the plane
Setpoint center point coordinate, 3rd axis of the plane
Actual ball diameter
Measuring variants
3.3 Measure workpiece (milling)
Unit
-
Degrees
Unit
Degrees
Degrees
mm
mm
mm
mm
mm
mm
-
-
-
-
Unit
mm
mm
mm
mm
mm
213