Log "Last Measurement - Siemens SINUMERIK 840D sl Programming Manual

Description
2.14 Miscellaneous functions
Examples of the selected storage location:
1. NC data -> Workpiece -> Workpiece "Logs"
//NC:/WKS.DIR/PROTOKOLLE.WPD
2. Network drive logs
//d:/Logs
3. USB -> measuring_cycle_logs
//USB:/01/measuring_cycle_logs
Name of log file
The log file name can be freely selected. It must comply with the rules for program names in
the NC, or for program names when writing to external drives.
File type
The following file types are supported:
● Text file - type TXT
● Tabular format – type CSV
These file types depend on the selected log format.
The file type cannot be changed, it is only displayed.
2.14.3.3

Log "Last measurement"

Function
The "Log last measurement" function is programmed by calling the logging CYCLE150 once.
Measuring is not performed, instead the values of the last measurement which are still available
in the result parameters of the measuring cycles (GUD variables) are used, and only a subcycle
is called for the logging. This function only makes sense when log "Off" was selected during
the measurement.
Requirement
A standard log can only be output when a measuring cycle was previously active in automatic
mode.
Procedure
A part program for logging "Last measurement" is created and is in the editor.
64
Programming Manual, 12/2017, 6FC5398-4BP40-6BA1
Measuring cycles