Siemens LMV5 Series Technical Instructions page 280

Technical Instructions
Document No. LV5-1000
Legend to address table
Access
Data format
[ ]
* These parameters do not need to be continually written since they are stored in EEPROM,
which only permits a limited number of write accesses over its lifecycle (< 100,000).
Data types
TYPE
Percent
Percent
Degrees
Process units
Fire rate
Adaption list
Section 8
R
R / W
S16
U16
S32
Phys. Int. range
0...100 % 0...1000
0...110 % 0...1100
-3.0...93.0° -30...930
0...2000° 0...2000
32...3632 °F 32...3632
0...100 bar 0...1000
0...1449 psi 0...1449
Modulating 0...1003
operation: 0...100 %
Multistage operation:
1001 = stage 1
1002 = stage 2
1003 = stage 3
0: Undefined
1: Identification completed, parameter determined
2: Undefined
3: Adaption aborted by user
4: Temperature differential too small, temperature will be lowered with low-fire
5: Monitoring time running
6: Delivery of identification load set
7: Error during identification (path)
8: Error during identification (internally)
9: Monitoring time running
10: Changeover from modulating to multistage during an identification
11: Timeout monitoring time
12: Timeout heating output on path with monitoring
Page 10
HOME
Value can only be read
Value can be read and written
16 bit integer, subject to sign
16 bit integer, not subject to sign
32 bit integer, subject to sign
Note:
In the AZL..., this data type is also
used to mark an invalid or non-
available value by using the value
of «-1»
Data array
Resolution Conversion int. / phys.
0.1 % / 10
0.1 % / 10
0.1° / 10
1 °C 1
1 °F 1
0.1 bar / 10
1 psi 1
Modulating Modulating operation:
operation: / 10
0.1 %
Multistage operation:
Multistage - 1000
operation:
1
LMV Series
SCC Inc.