Setting the bar shape of the highlight area
When you select [Bar] or [Preset] in step 3 of "Applying the Lighting effect"
(page 523), use the following procedure to set the shape of the bar.
1
2
524
DME Special Effect Operations
a) You can make the Lighting effect more effective by adjusting [Total Ambient] to lower the
brightness of the entire image. This setting is used both by this effect and by the
Spotlighting effect.
Note
The Total Ambient parameter is not supported on the MVE-8000A.
• When Preset is selected
Knob
Parameter
1
Light
2
Ambient
3
Shade
5
Total Ambient Brightness of whole image
a) Setting is available when nonlinear effect page turn, roll, cylinder, or sphere is selected.
b) You can make the Lighting effect more effective by adjusting [Total Ambient] to lower the
brightness of the entire image. This setting is used both by this effect and by the
Spotlighting effect.
Note
The Total Ambient parameter is not supported on the MVE-8000A.
Shade area
Highlight area
The three regions for which the light intensity can be set
Turn [Light Modify] on.
Adjust the following parameters.
Adjustment
Intensity of light in highlight area 0.00 to 100.00
Intensity of light in ambient area 0.00 to 100.00
Intensity of light in shade area
Setting values
a)
0.00 to 100.00
b)
0.00 to 100.00
Ambient area