Effect Execution; Master Timelines; Sequence Of Keyframe Operations - Sony DVS-9000 System User Manual

Hide thumbs Also See for DVS-9000 System:

Table of Contents

Effect Execution

By using the [RUN] button in the keyframe control block, you can replay the

effect as a continuous sequence of images. This is referred to as effect

Range of execution

Each time the [RUN] button is pressed, the range of execution of the effect is

from timecode 01:00:00:00 or the current time (the position at which the

current effect is stopped) to the end point of the effect. However, if there is a

pause set on a keyframe, the execution range is up to that point. Pressing the

[RUN] button again resumes the effect, which then runs to the next pause point

or the end of the effect.

Run mode setting

You can select from the following run modes for when the effect is executed.

DIRECTION: Specify the effect execution direction.

STOP NEXT KF: Run the effect, and stop at the next keyframe.

EFFECT LOOP: Repeat the effect in an endless loop.

Make these settings in the keyframe control block. (See "Run mode setting"

(page 633).)

You can save the regions selected for a keyframe effect and the register

numbers saved in the regions in a master timeline register so that operation can

be applied to two or more regions at a time.

Master timeline registers can be saved or recalled from the numeric keypad

control block or using a menu operation.

For more details, see "Creating and Saving a Master Timeline" (page 671).

The following table shows the principal operations involved in the sequence

from creating keyframes to executing an effect. For details of each operation,

see the page number in parenthesis.

For the overview of keyframes, see "Keyframes" in Chapter 1 (Volume 1).

Dvs-9000sf system