Assigning a DME to a key
1
In the M/E-1 >Key1 menu, select HF5 'Processed Key.'
The Processed Key menu appears.
2
In the <DME Select> group, select the DME channel (DME1 to DME4) to
be used.
The lit colors of [DME1] to [DME4] indicate the DME assignment.
Lit green: Shows the DME assigned to the currently selected key.
Lit amber: Shows the DME assigned to a key other than the currently
selected key.
Off: DME is not assigned.
Note
When assigning two to four DME channels to one key, the selected DME
channels must be successive.
To select a DME being used by another keyer
Press [Override], turning it on, then select the DME channel.
The later selection is valid, and the button lights green.
You can check the DME operating status in the Status menu (see page 330).
Selecting the video signal for the DME assigned to a key
For the operating procedure, see"Selecting the video signal for a DME
assigned to a key" (page 184).
Assigning a DME output signal as a monitor signal
1
In the Processed Key menu, press [Monitor].
The Monitor menu appears.
2
Press [Monitor Set], turning it on.
3
In the <DME Select> group, select the DME channel (DME1 to DME4) to
be used.
This assigns the selected DME output to DME MON V and DME MON K.
The colors with which [DME1] to [DME4] are lit show the key assignment
status.
Lit green: DME currently being monitored
Lit amber: DME that can be monitored
Key Setting Operations Using Menus
179