Parallel Output Settings (Output Config Menu); Assigning A Gpi Output Port - Sony DVS-9000 System User Manual

Parallel Output Settings (Output Config
Menu)
For the DCU parallel output ports, after carrying out tally settings in the
Router/Tally >Tally Enable menu, you can assign GPI outputs to output ports
that are still unused.
To assign DCU outputs to DCU parallel output ports, display the DCU >Output
Config menu.
To display the Output Config menu
In the Engineering Setup menu, select VF5 'DCU' and HF3 'Output Config.'
The status area shows output port information.

Assigning a GPI Output Port

1
In the DCU >Output Config menu, select what the setting applies to
(DCU1 or DCU2) from the <DCU Select> group.
2
In the <Parallel Output Assign> group, press [GPI Output].
3
Using any of the following methods, select the output port and GPI output
number.
• Press directly on the list in the status area.
• Press the arrow keys to scroll the reverse video cursor.
• Turn the knobs.
Knob
1
2
5
a) When the MKS-2700 is connected, select 2.
b) When the MKS-2700 is connected, select a value in the range 1 to 36.
4
To confirm the selected setting, press [GPI Output Set].
This confirms the selection, which is reflected in the status area.
Parameter
Parallel Output Slot
Parallel Output Port
GPI Output
Adjustment Setting values
Output port slot
2 to 6
Output port
1 to 54
GPI output 1 to 50

Parallel Output Settings (Output Config Menu)

a)
b)
997