Other Key Setting Operations - Sony DVS-9000 System User Manual

Selecting the video signal for the DME assigned to a key
For the operating procedure, see"Selecting the video signal for a DME
assigned to a key" (page 184).
Assigning the DME output signal to a monitor signal
1
Holding down the output destination specification button [MON] in the
key control block, use the DME channel selection buttons to select the
DME channel (DME1 to DME8) you want to use.
The selected DME output is assigned to DME MON V and DME MON K.
2
To check the DME assignment status, hold down just the [MON] button.
While it is held down, the lit color of the [DME1] to [DME4] buttons
shows the key assignment status.
Lit green: Shows the DME currently being monitored.
Lit amber: Shows a DME which can be monitored.
Off: DME is not assigned.

Other Key Setting Operations

Using an external processed key
You can select and use the key processed keyer key fill and key source signals
on the AUX buses.
1
Select the keyer to be allocated.
2
In the key control block, press [PROC KEY], turning it on.
The button lights amber, and on the currently selected keyer, the key fill
and key source are assigned to reentry signals PROC V and PROC K.
When a DME is selected on the currently selected keyer, the key fill and
key source signals to which the DME effect is applied are assigned to
PROC V and PROC K.
Note
You cannot select the PROC V and PROC K signals using the cross-point
selection buttons of the M/E or PGM/PST bank.
Key Setting Operations With the Key Control Block
195