Adding User Texture Patterns - Sony DVS-9000 System User Manual

A confirmation message appears.
6
Press [Yes].
A license registration canceled message appears.
7
Press [OK].
The status area Condition box showing "Active" changes to blank.
8
Using either of the following methods, restart the device.
• In the System >Initialize menu, select only the device for which you
registered the license, and press [Reset] in the <Initialize> group.
• Power off and on again.
After restarting, the software for which the license registration has been
canceled is no longer available.

Adding User Texture Patterns

You can add user created texture patterns to the repertory of texture patterns
with which the spotlighting function enables the light falls on the image
surface.
Note
This function is not supported on the MVE-8000A.
For details of spotlighting and texture patterns, see "Spotlighting Settings" in
Chapter 11 (Volume 2).
The procedure for adding a texture pattern is as follows.
Prepare the texture file (next item)
Create the texture package (page 856)
Install the texture package (page 858)
To prepare a texture file
Create a texture file meeting the following conditions, and save it on a memory
card.
File format: Windows bmp ("bitmap") (extension: bmp, 24-bit RGB)
File name: alphanumeric (maximum 8 characters) + extension (bmp)
m
m
Installation and Device Setup (Install/Unit Config Menu)
853