Advertisement
Installation Instructions
[_A1-FACH THE WATER VALVE (cont.)
• Clip the end of the ground
wire to the
refrigerator
cabinet.
IMPORTANT:
To ensure
a proper
ground,
the end of the ground
wire MUST be secured
to the refrigerator
cabinet.
I_CONNECT
WATER TUBE
TO INLET
• Squeeze
the ends of the hose damp
(3 or 6) from
the kit with pliers and slide the clamp over the
inlet, located
on the right side of the refrigerator.
• While still squeezing
the damp,
insert the free end
of the water tube (4) into the inlet as far as it will go.
• Then
slide the clamp downward
to capture
the
water tube in place.
• Using one of the adhesive-backed
fasteners (5),
secure the water tube to the back _ffthe refrigerator
about 1/2" below the inlet.
Inlet _(_)(_
(_) or
[] INSTALL WATER LINE CLAMP
• Attach
the water line clamp
(strain
relief)
(8)
from the kit to the refrigerator. With the clamp
directly in line with the water valve, drive the
screw (7) from the kit through
the clamp
(8)
at the indent
into the back of the cabinet.
• The metal clamp
is for the house water line (see
Water Line Installation
Instructions).
It is not to
be used for the water tube from the water valve
up to the inlet.
[] ROUTE AND ATTACH
THE
WATER TUBE
• Fasten the plastic water tube to the back of the
refrigerator with three of the adhesive-backed
fasteners (5), spacing the fasteners as shown.
(_
Adhesive-backed
fastenersfor
watertube
[_ WATER VALVE INSTALLED
Refer to the Water
Line Installation
Instructions
for connection
to the home
water supply. After
water line installation
is completed,
set the
icemaker
power
switch to I (on).
Even when the icemaker
power switch is in the
I (on) position,
power to the icemaker
will be
interrupted
when
the freezer
door/drawer
is open.
This prevents
ice ejecting
from the icemaker
from
missing the ice bucket
and dropping
into the back
of the freezer.
Because
power to the icemaker
is
interrupted
while the door/drawer
is open,
the
green power light on the icemaker
will be off. To
make sure the icemaker
is working
properly,
press
the freezer
light switch located
on the upper
right
side of the freezer
compartment.
The power light
on the icemaker
will come on.
Note: After installing
the icemaker,
do not open
the door/drawer
for approximately
4 hours.
This
will allow the freezer
to reach
the correct
operating
temperature
for making
ice, and will prevent
water
from spilling
out of the icemaker
mold.
61
Advertisement
