Advertisement
Installation Instructions
I_INSTALL
WATER LINE CLAMP
• Attach
the metal water line clamp (strain relief)
(8) to the refrigerator.
Drive one of the screws,
removed
in Step 1, into the cabinet
edge through
the clamp and hole in compressor
cover.
• The metal clamp
is for the house
water line (see
Water
Line Installation
Instructions).
It is not to
be used for the tubing
from the water valve up to
the icemaker.
Screw
141CONNECT THE WATER LINE
• Remove the small plastic cap (B) from the bottom
of the water tube inlet located
in the upper-right
rear corner
of the refrigerator.
• Squeeze the ends of the hose clamp
(6) from the
kit with pliers mad slide the clamp
over the water
tube inlet.
• While still squeezing
the clamp, insert the
plastic water line into the inlet as far _ it will
go (approximately
1" [25 mm]).
• Then slide the clamp downward
to capture
the
plastic water line in place.
• Make sure the fill tube is aimed down.
inlet
@
[]
ROUTE AND ATTACH THE
PLASTIC WATER LINE
• Route
the plastic water line along the back of the
refrigerator
to the water tube inlet.
• Use the three adhesive
backed fasteners
(5) to
secure
the plastic water line to the case back.
Adhesive-backed
fasteners for plastic
water l ine
[] WATER VALVE INSTALLED
Refer to the Water Line Installation
Instructions
for connection
to the home water supply. After
water line installation
is completed,
set the
icemaker
power switch to I (on).
The icemaking cycle will not begin until the icemaker
and freezer compartment reach operaang temperature,
then icemaking will begin automatically.
37
Advertisement
