Advertisement
Installation Instructions
[] INSTALL
WATER
LINE CLAMP
• Push the metal water line clamp (strain relief) (19)
onto the lower flange of the cabinet back, directly
in line with the water valve.
• The metal clamp
is for the house water line. (See
the Water Line Installation
Instructions).
It is not
to be used for the tubing
from the water valve up
to the icemaker.
I_CONNECT
THE WATER LINE
• Ensure
that you have sufficient
length of plastic
tube to extend
well into the water tube inlet.
Cut off excess tubing.
• Squeeze
the ends of the hose damp
(3) from
the kit with pliers and slide the clamp over the
water uthe inlet.
• While still squeezing
the clamp,
insert the
plastic water line into the inlet as t_tr as it will
go (approximately
1" [25 ram]).
• Then slide the clamp downward
to capture
the
plastic water line in place.
• Make sure the fill tube is aimed down.
2
Water t ube
[]ATTACH
THE PLASTIC WATER
LINE
Route
the plastic water line along the back of the
refrigerator
to the icemaker
hole in the case back.
Use three of the adhesive-backed
fasteners
(5) to
secure
the tube to the case back.
@
Adhesive-backed
fasteners for plastic
waterline
[] WATER VALVE INSTALLED
Refer to the Water Line Installation
Instructions
for
connection
to the home water supply. After water
line installation
is completed,
set the icemaker
power
switch to I (on).
The icemaking cycle will not begin until the icemaker
and freezer compartment
reach operating temperature,
then icemaking will begin
automaticatty.
29
Advertisement
