Advertisement
Installation Instructions
ICEMAKER INSTALLATION INSTRUCTIONS []
Are these
the right instructions
for your
model?
Follow
the Installation
Instructions
indicated
by
the label
on the back of the refrigerator--
[] []
[]
[] []
[]
[]
[] []
[]
[]
[] or []
BEFORE YOU BEGIN
Read each step thoroughly
before
proceeding.
° CAUTION-
Unplug the
_
Refrigerator.
To eliminate
the danger
of electric
shock during
installation,
you must unplug
the refrigerator
from its electrical
outlet.
TOOLS YOU WILL NEED
Flatbladeand Phillips
Pliers
screwdrivers
Sharpknife
[] REMOVE PLUG COVER
Remove
the electric
plug cover.
To remove
the type shown in Fig. 1,
insert a standard
screwdriver
blade
in slot at bottom
of cover, apply
pressure
upwards,
and pry cover
away from freezer
wall. Discard
this cover.
To remove
the type shown in
Fig. 2, press top of cover down
to free its upper
tab from slot in
freezer
wall. Then
pull cover
straight
out to free the lower tabs
from their slots. Save this cover
for reinstallation
later.
Fig.2
[_LOOSEN MOUNTING
SCREWS
Loosen
the two mounting
screws (A) but do not
screw them all the way out. The screws should
extend
approximately
i/2"
(13 mm) out from the
freezer wall.
[] INSTALL FILL TUBE EXTENSION
• Remove
and discard
the white plug from
the
upper
left corner
of the freezer
wall.
• Cut the Fill tube extension
(10) to the []
length
(refer to the []
template
on page 67) with a
sharp knife or a single-edge
razor blade
and slide
it onto
the fill tube against
the stop.
[] SET POWER SWITCH
TO O (off)
Set the icemaker power switch to O (off'). Leave
the power switch in the 0 (off) posidon
until the
refrigerator
is connected
to the water supply to
prevent
premature
operation.
Power
Switch
wiretie
[] POWER CORD ADAPTER
There are two power cord adapters
included
with the
kit; be sure to use the one specified in the Parts List
on page 7. Plug the female end of the power cord
adapter
09) onto the male terminals
on the icemaker
power cord. When connecting
the adapter
to the
power cord, make sure the seal is in place between
the connectors.
Secure the power cord adapter
to
the icemaker
by putting it into the hook at the back
of the icemaker
and attaching
it to the icemaker
with awire fie (22).
14
Advertisement
