Advertisement
Installation Instructions
ICEMAKER INSTALLATION INSTRUCTIONS
[]
Are these
the right instructions
for your
model?
Follow
the Installation
Instructions
indicated
by
the label
on the back of the refrigerator--
[] []
[]
[]
[] []
[]
[]
[] []
[] []
or []
BEFORE YOU BEGIN
Read each step thoroughly
before proceeding.
• CAUTION
- Unplug,be
Refrigerator.
To eliminate
the danger
of electric
shock during
installation,
II
you must unplug
the refrigerator
from
\\
tQ"/
its electrical
outlet.
\
TOOLS YOU WILL NEED
Flatblade andPhillips
Pliers
screwdrivers
Sharpknife
[] PREPARE FOR INSTALLATION
• Remove
the storage
basket
(on some models)
by pulling
it out to the
stop position
and lifting
it up and out.
Note: After removing
the basket,
push
the
extension
arms back
into the freezer
compartment.
• Remove
the chiller
shelf
(on some models)
by
pulling
it straight out.
• Remove
the ice bucket
by pulling it out and
lifting it up and out.
• Remove
the
center
vertical
shelf
support
(on some
models)
by
lifting
it and
rotating
its bottom
to the right.
[] PREPAREFOR INSTALLATION (cont.)
• Inside
the freezer,
remove
the two small white
plug buttons
(on some models)
from the side
wall. (If screws are present
instead
of plugs,
leave them in olace.)
"
Insulation
• Remove and discard
the large white plug
from the rear freezer
wall. Pull out the gray
insulation
plug and
remove
any debris.
• Remove the outlet
cover with a flat-blade
screwdriver.
Remove
side wall_ug
buttons orleave
s crews
plug
inplace
[] INSTALL
FILL TUBE
• Slide the till tube shipped
with the refrigerator
onto the
water tube inlet (15). ffthe
fill
tube has been misplaced,
call
1.800.696.2002
and order part
WR02X11712.
• Go to the back of the refrigeraton
Remove the label covering
the
hole. Pull out the insulation
plug
and any debris.
• On the tube side of the water tube
inlet (15), there is an adhesive
backing.
Remove the adhesive
backing and slide the tube into the
hole at the back of the refrigerator.
Firmly press on the inlet to secure
it to the refrigerator.
[] SET POWER SWITCH
TO O (off)
Set the icemaker power switch to O (off). Leave
the power switch in the O (off) position
until the
refrigerator
is connected
to the water supply to
prevent
premature
operation.
58
Advertisement
