Advertisement
Installation Instructions
I_CONNECT
THE WATER LINE
• Make sure there
is enough
plastic water line to
extend fi-om the water valve to well into the water
tube inlet (15). Cut off any excess tubing.
• Squeeze the ends of the hose damp
(3) from the
kit with pliers and slide the clamp over the water
tube inlet.
• While still squeezing
the clamp, insert the
plastic water line into the inlet as far as it will
go (approximately
1" [25 mm]).
• Then slide the clamp downward
to capture
the
plastic water line in place.
• Make sure the fill tube is aimed down.
Water t ube
inlet
,®
[]WATER
VALVE INSTALLED
Refer to the Water Line Installation Instructions
for connection
to the home water supply. After
water line installation is completed,
set the
ieemaker power switch to I (on).
The icemaking cycle will not beg_nuntil the icemaker
and fre_er compartment reach operating _,
then icemaking will beg_nautomatical_.
[]
ROUTE AND ATTACH THE
PLASTIC WATER LINE
• Fasten the plastic water line to the back of the
cabinet
with adhesive-backed
fasteners
(5),
spacing the fasteners as shown to take up slack
in the line.
I
__hes_w-backed
fasteners
for plastic waterline
49
Advertisement
