Advertisement
Installation Instructions
13]CONNECT
THE WATER LINE
• It may be necessary
to remove
the
screw
from
the
top fight
condenser
mounting
clip for better
access
to the
water
tube
inlet.
• Make sure there
is enough
plastic water line to
extend
from the water valve to well into the
water tube inlet (15). Cut offany
excess tubing.
• Squeeze
the ends of the hose damp
(3) from the
kit with pliers and slide the clamp
over the water
tube inlet.
• While still squeezing
the clamp,
insert the plastic
water line into the inlet as far as it will go
(approximately
1" [25 mm]).
• Then slide the clamp
downward
to capture
the
plasdc water line in place.
• Make sure the fill tube is aimed
down.
• If the condenser
mounting
screw was removed,
secure the condenser
to the refrigerator
by
replacing the moundng
clip and screw.
• Do not overfighten
the screw.
Water t ube
inlet
,_
[] WATER VALVE INSTALLED
Refer to the Water Line Installation
Instructions
for connection
to the home water supply. After
water line instaUation
is completed,
set the
ieemaker
power switch to I (on).
The icemaking cycle will not begin until the icemaker
and _
comparlment
reach operating temperature,
then icemaking will begin automatical_.
[]
ROUTE AND ATTACH THE
PLASTIC WATER LINE
• Fasten the plastic
water line to the back of the
cabinet
with adhesive-backed
fasteners
(5),
spacing
the fasteners
as shown to take up slack
in the line. (It may be necessary
to remove
the
screw from the top fight condenser
mounting
clip for better
access to the water tube inlet.)
) Adhesive-_cked fasteners
forplasticwaterline
53
Advertisement
